the hacking the automotive fleet say Toyotas or a common sensor component, and using this. The points are the following: center front, center right, center rear, center left. This point should justify a slightly larger spend on military. Positions of the bed reference points in the machine coordinates, referenced to the P.I.N.D.A sensor. I was planning on building a new i3 out of extrusion and sheet (I have some frame stuff figured out already), and use the MK42 bed and old PINDA probe along with the MK3's branch of Marlin so I could have all the Trinamic features as well as bed leveling with the MK42 bed.Ĭan I use the old PINDA with the mk3's firmware, somehow disabling the thermistor? Could I just use a 100k thermistor glued on? Also, are the bed leveling dots in the same place on the MK42 and MK52 beds? If not, I found on line 571 '#define HEATBED_V2' in Configuration_prusa.h - but I'm not sure what that function is.ĮDIT: It appears that HEATBED_V2 is defined in mesh_bed_calibration.cpp, but not sure what I do from here. Inductive Proximity Sensor, ICS Series, Cylindrical, 0.8 mm, PNP-NO, 10 to 30 Vdc, Pre-wired. So I got a MK3 kit that's on the way, as well as an EINSY RAMBO board, a MK42 bed, the old PINDA version, a 24v supply and my old i3.

Mk52 induction sensor point